Standardization and accuracy of millimeter endodontic rulers
DOI:
https://doi.org/10.33448/rsd-v12i5.41623Keywords:
Endodontics, Odontometry, Standardization, Accuracy.Abstract
Objective: To evaluate and compare the standardization and accuracy of millimeter endodontic rulers among three different brands available on the market, comparing their lengths with the standard measurement of the caliper. Methodology: This is a quantitative laboratory study where thirty rulers were selected and included in 3 groups of 10, according to the commercial brand: 1. Prism; 2. MK Life and 3. Maquira. In each ruler, the measurement of 15, 20, 25 and 30 mm was measured using an electronic digital caliper. As for standardization, the Student's t test was used (p < 0.05), whereas in relation to accuracy, the results were expressed through the average and average error of each group, thus comparing the results between the units of each group . Results: After the statistical analysis, the rulers produced by the brand Prisma and MK Life were standardized because they did not present significant differences (p > 0.05), in relation to accuracy they presented lower absolute mean errors, as they were closer to the nominal lengths , however, the Maquira ruler was the least standardized and accurate, according to the same tests analyzed. Conclusion: Prisma and MK Life endodontic rulers proved to be standardized and accurate. However, the Maquira brand endodontic rulers did not show standardization and accuracy.
Downloads
References
Abdelsalam, N., & Hashem, N. (2020). Impact of Apical Patency on Accuracy of Electronic Apex Locators: In Vitro Study. Journal of endodontics, 46(4), 509–514. https://doi.org/10.1016/j.joen.2020.01.010
Alencar, A. H. G., Bruno, K. F., Arruda, M. F., & Barnabé, W. (2005). Standardization and accuracy of endodontic milimetered rulers used for endodontic odontometry. Rev Odontol UNESP, 34(2), 79-83 http://repositorio.bc.ufg.br/handle/ri/16391
Araújo, I. S., Silva, M. M. S., & Tavares, M. N. S. (2021). Relação entre o forame apical e o ápice radicular em dentes anteriores superiores humanos. Archives of health investigation, 10(5), 691–695. https://doi.org/10.21270/archi.v10i5.4939
Braitt, A. H., Bomfim, S. L., Santos, C. H. B., Andrade, C. A., & Freire D. C. A. M. (2022). Selamento de perfuração com técnica de inserção modificada do MTA: relato de caso clínico. Revista Odontológica de Araçatuba, 43(1), 0971, janeiro/abril. https://pesquisa.bvsalud.org/portal/resource/pt/biblio-1361569
Bürgel, M. O., & Borba, M. G. D. (2011). Análise (SEM) da anatomia apical de pré-molares inferiores. Revista da Faculdade de Odontologia da Universidade de Passo Fundo, 16 (1), 49-53. http://revodonto.bvsalud.org/pdf/rfo/v16n1/a11v16n1.pdf
Dadalti, M. T. D. S. A., Dias, B. D. M., Bruno, A. M. V., & Riso, P. D. A. (2021). Precisão de réguas endodônticas milimetradas e orifício calibrador, e avaliação da regularidade da superfície do orifício calibrador. Dent. press endod, 40-45. https://pesquisa.bvsalud.org/portal/resource/pt/biblio-1379003
de Mattos, F. P. S., & Marchionni, A. M. T. (2021). Endodontia e sepultamento radicular como tratamento conservador em paciente submetido à radioterapia: Relato de caso / Endodontics and burial root as a conservative treatment in undergone radiotherapy patient: Case report. Brazilian Journal of Development, 7(12), 114300–114314. https://doi.org/10.34117/bjdv7n12-284
ElAyouti, A., Connert, T., Dummer, P., & Löst, C. (2022). A critical analysis of research methods and experimental models to study working length determination and the performance of apex locators - A narrative review with recommendations for the future. International endodontic journal, 55 Suppl 2, 281–294. https://doi.org/10.1111/iej.13738
Khan, S. A., Khanna, R., Navit, S., Jabeen, S., Grover, N., & Pramanik, S. (2022). Comparison of Radiovisiography, an Apex Locator and an Integrated Endomotor-inbuilt Apex Locator in Primary Teeth Endometrics. International journal of clinical pediatric dentistry, 15(Suppl 1), S18–S21. https://doi.org/10.5005/jp-journals-10005-2123
Laslami, K., Dhoum, S., El Harchi, A., & Benkiran, I. (2018). Relationship between the Apical Preparation Diameter and the Apical Seal: An In Vitro Study. International journal of dentistry, 2018, 2327854. https://doi.org/10.1155/2018/2327854
Lins, R. P., Menezes, L. V. P., Araújo, R. P. C., Silva, S. J. A., & Mendes, C. M. C. (2015). Exatidão e precisão das réguas milimetradas utilizadas durante procedimentos endodônticos. Revista De Ciências Médicas E Biológicas, 14(3), 286–292. https://doi.org/10.9771/cmbio.v14i3.14988
Meirinhos, J., Martins, J. N. R., Pereira, B., Baruwa, A., Gouveia, J., Quaresma, S. A., Monroe, A., & Ginjeira, A. (2020). Prevalence of apical periodontitis and its association with previous root canal treatment, root canal filling length and type of coronal restoration - a cross-sectional study. International endodontic journal, 53(4), 573–584. https://doi.org/10.1111/iej.13256
Nogueira, A. P. C., de Albuquerque, B. B., Silva, M. C. D., & Vieira, V. T. L. (2021). Avaliação da Fidedignidade de Diferentes Marcas de Réguas Endodônticas Milimetradas Assessment of the Reliability of Different Millimeter Endodontic Ruler Brands. Brazilian Journal of Development, 7(12), 113227-113234. https://doi.org/10.34117/bjdv7n12-212
Paiva, H. C., Borelli, A. L., de Almeida, M. O., Sá, D. P., Akisue, E., & dos Santos, R. L. O. (2022). Odontometria eletrônica em dentes decíduos: revisão de literatura e relato de caso. Revista Da Faculdade De Odontologia De Porto Alegre, 63(1), 98–105. https://doi.org/10.22456/2177-0018.117180
Pauletto, G., & Bello, M. (2018). O impacto da patência apical para o sucesso do tratamento endodôntico: uma revisão de literatura. Revista Da Faculdade De Odontologia da Universidade de Passo Fundo, 23(3), 382-388. https://doi.org/10.5335/rfo.v23i3.8726
Raldi, D. P., Lage Marques, J. L. S., Antoniazzi, J. H., & Frois, I. M. (1999). Precisão de instrumentos para aferição do comprimento de trabalho em endodontia. Odontologia USF, 17(ja/dez. 1999), 17-23. https://pesquisa.bvsalud.org/portal/resource/pt/lil-271297
Thorley W. (2021). Working length determination. British dental journal, 230(1), 5. https://doi.org/10.1038/s41415-020-2562-y
Travassos, R. M. C., Prado, V. F. F. do, Oliveira, A. C. C. de, Silva, A. R. N. da, Bezerra, A. N. C., Fonseca, T. C., Silva, D. H. das N., Moisés, L. de S., & Melo Júnior, P. M. R. de. (2021). Avaliação comparativa da odontometria eletrônica com a radiográfica. Research, Society and Development, 10(15), e113101522411. https://doi.org/10.33448/rsd-v10i15.22411
Ugincius, P., Kubilius, R., Gervickas, A., & Vaitkus, S. (2006). Chronic odontogenic maxillary sinusitis. Stomatologija, 8(2), 44–48. https://pubmed.ncbi.nlm.nih.gov/16861848/
Victorino, F. R., Lustosa-Pereira, A., Bernardineli, N., Garcia, R. B., Moraes, I. G. D., & Bramante, C. M. (2012). Analysis of accuracy of endodontic millimeter rulers of different commercial brands. RGO. Revista Gaúcha de Odontologia (Online), 60(3), 305-308. http://revodonto.bvsalud.org/scielo.php?script=sci_arttext&pid=S1981-86372012000300004
Zahran, S., Mannocci, F., & Koller, G. (2022). Assessing the Iatrogenic Contribution to Contamination During Root Canal Treatment. Journal of endodontics, 48(4), 479–486. https://doi.org/10.1016/j.joen.2022.01.007
Downloads
Published
Issue
Section
License
Copyright (c) 2023 Danilo Teixeira Macêdo ; Itallo Matheus Macário Alencar de Sousa; Luciana Reinaldo Lima; Carlos Alberto Monteiro Falcão; Giselle Torres Feitosa
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors who publish with this journal agree to the following terms:
1) Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
2) Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
3) Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work.
